Hubsan MINI - Page 22

22
rTH PrOCESS
Make sure whose take-off point has been registered (Home)1
During the RTH phase the Drone will search for the landing mat. Make sure this fea-
ture has been activated.
Activate the following parameters to perform RTH:
1 - Set the altitude of the done duing rTH;
2 - Activate the Landing Pad seach if necessay;
a) Regardless of the flight altitude if the Drone is within 5 meters from the lan-
ding base, it can land regularly;
b) If the distance from the landing point is between 5 and 20 meters you can re-
return to the landing point with the same altitude.
c) Starting from 20 meters from the take-off point if the altitude of the Drone is
higher than that defined by the application, the drone performs the RTH without
modification the altitude. On the contrary, if the altitude is lower than that defi-
ned in the application the Drone will rise to perform the RTH and finally land.
2
3
r T H P r O C E S S W I T H O N E K E Y
From the remote control press the RTH button. - From the App press the RTH button
rTH PrOCESS FOr LOW BATTErY
The flight controller will display a warning if the battery is low. If the battery charge is in-
sufficient the Drone will automatically return to the landing base, otherwise it will land di-
rectly. Furthermore, in the absence of a GPS signal, the Drone will land directly.
After normal or forced landing due to low battery, if the charge is less than 10%, the
Drone enters protection mode: it deactivates image transmission but preserves nor-
mal data communication.
The emergency battery voltage is automatically calculated based on the altitude and
flight distance.
2
1
rTH DUE TO CONNECTION LOSS
When the Drone loses connection with the Radio Control for more than 5 seconds, it returns
to the take-off point and lands automatically.
If the connection is restored during the return flight, the return flight may be can-
celled.
After the Drone has lost the connection for more than 5 seconds it will activate the RTH.
2
1
Direct landing in the absence or weak GPS signal strength.3
The moment the Drone re-establishes the connection, the priority control signal es-
tablishes a connection. If the image connection is not re-established within 10 sec-
onds after the signal is re-established, the image connection can also be activated
from the shortcut button.
4
Duing a foced take-off, in the absence of GPS signals, if duing
the flight the Done locks onto the GPS signal, it will ecod that
point as the initial take-off position and theefoe rTH.