If using the optional inner Dataset
®
arm, refer to “Split Spoke Feature,” page 53. This
measurement can be input automatically, if the DSP9200 is equipped with the
optional auto inner and/or outer Dataset
®
arms. Refer to “Measure the Wheel with
Inner and Outer Auto Dataset
®
Arm(s),” page 26.
Close safety hood and spin wheel.
After wheel stops, raise safety hood.
Find TDC for left plane and attach clip-on weight, or find BDC for left plane and
attach adhesive weight.
CLIP-ON/ADHESIVE
LEFT PLANE TDC
ADHESIVE/ADHESIVE
LEFT PLANE BDC
(BLINKING)
If necessary, use the “Left Plane Split Weight
®
” to split weight.
The 360 degree weight angle display can be used to place the adhesive weight at
Bottom Dead Center (BDC) for easier and more accurate placement than the
conventional TDC method. If TDC placement is desired, press the
“Stop”
button to disable Servo Stop. Rotate the wheel to TDC and attach weight.
The Dataset
®
arm may be used as a reference device for locating previously input
placement position of adhesive weight on left or right plane. If equipped with an
optional inner auto Dataset
®
arm, servo to locate an adhesive weight at BDC, then
trigger the Dataset
®
arm to begin Servo Aided Weight Placement. Refer to “Servo
Aided Weight Placement,” page 47.
38
3. Balancing a Wheel DSP9200 Series Balancer Operation Instructions
To Next Page
Loading...