5. EQUIPMENT INFORMATION
5.1 Software Identification
Selecting “Identify Software” from the logo screen will display the software version.
Trademarks may also be viewed from this screen.
5.2 Program Cartridge and Security Key Removal and Installation
Remove the rear cover from the support assembly for the LCD display by removing
the six #8 screws. Set the rear cover and attaching hardware aside.
Insert to program cartridge into the cartridge jack located on the side of the board
within the support assembly. Verify that program cartridge is fully seated.
PROGRAM
CARTRIDGE
INSTALLED
SECURITY KEY
INSTALLED
GSP9720JLR Wheel Balancer Operation Instructions Equipment Information
111
To Next Page
Loading...
