Primary Balancing Display
The control knob can also be used to switch between SmartWeight and traditional
balancing, as long as both traditional and SmartWeight modes are enabled in setup.
Press the knob until the SmartWeight is highlighted or the hand appears on the
static/dynamic switch. Next, press and hold the control knob until the opposite
balance mode icon appears.
NOTE: If SmartWeight mode is enabled, the balancer will always
return to SmartWeight balancing upon dimension entry or a
reset.
Resetting the Program
The wheel balancing program may be reset at anytime by using the key, located
on the LCD support console directly beneath the LCD. To reset the balancer, press
the reset key twice within a four-second period without pressing any other keys in-
between. This prevents a single accidental keystroke from resetting the system.
When the balancer is reset, the information collected for the wheel balance in
progress is erased and the display returns to the “Logo” screen.
12
Getting Started GSP9720JLR Wheel Balancer Operation Instructions
To Next Page
Loading...
