PATCH BALANCE should be selected when the tire has a very large imbalance in
the tire assembly. The large imbalance can be corrected with Patch Balancing and
then the assembly can be fine-tuned with one of the other balancing procedures.
AUTO MODE Balancing Procedure
Selecting AUTO MODE will choose the correct type of weights and locations
determined by the placement of the Dataset® Arms. AUTO MODE incorporates
procedures of specific wheel balance methods as outlined below.
STANDARD Balancing Procedure Using Clip-On Weights
There are many types of clip-on weights. Determine the correct application before
installing weights.
Verify that the wheel is clean and free of debris.
Remove all previous weights.
Mount tire/wheel assembly. Refer to “Mounting the Wheel on the Spindle Shaft,” page 25.
Press
. Use the softkey arrows to select “STANDARD BALANCE” and press
“OK.”
Select either grams or ounces by rotating the control knob and highlighting either “g” or
“oz.”
Select “DYNAMIC” by rotating the control knob to highlight “
.” Refer to “Dynamic
Balancing Selection,” page 44.
50
Balancing Procedures GSP9720JLR Wheel Balancer Operation Instructions
To Next Page
Loading...
