Hunter GSP9700 Series - 3 Balancing Procedures; Mounting the Wheel Using Wheel Lift (Optional); Raising the Wheel Assembly

3. BALANCING PROCEDURES
3.1 Mounting the Wheel Using Wheel Lift (Optional)
The Wheel Lift is an optional feature on the Road Force / GSP9700 series balancer.
For instructions on mounting the tire/wheel assembly without the optional wheel lift,
refer to “Mounting the Wheel,” page 25.
Raising the Wheel Assembly
Slide the appropriate mounting cone onto the spindle.
Position wheel lift carriage at the end of the wheel lift rail.
Press the lift control handle “down” until the trolley carriage is at its lowest level.
Roll the wheel assembly onto the wheel lift carriage.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
x
23