Hunter GSP9700 Series - Re-Entering Similar Wheel after Split Spoke Is Enabled

Press the green “START” button if “Hood Autostart” is disabled. After wheel comes to
a complete stop, raise safety hood. Place left plane weight (if in DYNAMIC mode) per
the balance procedure being performed. Refer to “Balancing Procedures,” page 23.
SP OKE S OF WHEE L
SPOKE LOCATION SHOWN
POSITIONED AT DATASET
ARM HOLDER CONTACT
POINT WITH RIM
SERVO-AIDED ADHESIVE
WEIGHT PLACEMENT
Press the green “START” button with the safety hood in the RAISED position and the
GSP9720JLR will servo to the location for the right adhesive weight plane (dynamic)
or the static adhesive weight plane (static), aligned with the first spoke. With the
servo enabled, attach the adhesive weight behind the first spoke using the weight
amount shown on the LCD. Refer to “Servo-Aided Adhesive Weight Placement,”
page 61.
Press the green “START” button with the safety hood in the RAISED position and the
GSP9720JLR will servo to the location for the second spoke.
Attach the appropriate weight as displayed on the console. All weight plane displays
should show “zero.” SPLIT SPOKE® balancing procedure is complete.
Re-entering Similar Wheel after Split Spoke® is Enabled
Once Split Spoke® mode is enabled, use the “Set New Spoke Location” key to input
the spoke orientation of the other three rims from a set to avoid re-measuring the
weight plane dimensions each time. This can be performed with or without the laser.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
x
69