CAUTION: Quick-Thread does not tighten the wing nut! In Quick-Thread
rotation, torque allowed is minimal. Therefore, the wing nut
must still be hand-tightened before balancing.
NOTE: Also because of the software limited torque control, you
must loosen the wing nut before Quick-Thread will remove
it.
Quick-Thread will not operate under the following conditions:
If the balancer is in “Diagnostics,” “Setup,” or “Calibration.”
If either Dataset® arm is out of its “home position” while in the “Balance,”
“Current Runout & Loaded runout” or “Measure Rim Runout” screens.
3.4 CenteringCheck® Wheel Centering Feature
The CenteringCheck® wheel centering feature using Imbalance Forces or Location
can be used to inspect each mounting to identify possible centering errors, thus
preventing improper measurements from occurring.
CenteringCheck® may be used with either a “bare rim” or a “rim with tire assembly.”
On-screen prompts lead you through the procedure as follows:
Select “Perform CenteringCheck” from the menu.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
27
To Next Page
Loading...
