the vehicle in a clockwise fashion. Successive spins are stored as either “before” or
“after” data based on the following rules:
x If the weight displays read “OK/OK” or “---/---”, assume the next complete spin is
“before” data
x If the weight displays read anything other than “OK/OK” or “---/---”, assume the
next complete spin is “after” data
JLR BALANCE - The technician is prompted to identify the current wheel assembly
each time the balancer believes a spin will result in storing “before” data (according to
the previously stated rules).
“Prompt for Wheel Assembly ID” can be disabled in setup when “Standard Balance”
is selected from the Logo screen.
Storing Measurements
Verify that the wheel is clean and free of debris.
Remove all previous weights.
Mount tire/wheel assembly. Refer to “Mount the Wheel on the Spindle Shaft,” page
25.
Enter the rim dimensions using the Dataset® arms and select “Balance”.
Close safety hood.
Press the green “START” button if “Hood Autostart” is disabled.
NOTE: The following steps will take place automatically each time a
wheel assembly is balanced if “Prompt for Wheel Assembly
ID” is enabled in service mode setup and “JLR Balance” is
selected.
Press the “Menu Shift” until the “Store Measurements” selection is available.
Select “Store Measurements”. The measurements are stored for the front left
assembly.
Select “Exit” to continue.
Balance assembly and continue to the next assembly. The “Store Measurements”
screen will automatically progress to the next assembly in a clockwise direction.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
45
To Next Page
Loading...
