Repeat “Store Measurements” until all assemblies are complete.
Select either “Clear Before Measurements” or “Clear After Measurements” to use that
data at another wheel position.
To reset all stored measurements, Press the “Menu Shift”
until the “Clear Data”
selection is available. Select “Clear Data” and “OK” to reset.
Print Summary
A printout is available that incorporates a detailed image of each wheel assembly
with the stored measurements. If a measured value is out of tolerance compared to
the recalled specification, the value will be printed in red.
Select “Print Summary” to view the before and after results.
Select “Print” to send before and after balance summary results to the printer.
3.15 Balance Modes
Select the correct balance mode for each application using the control knob. Refer to
“Using the Control Knob,” page 11.
46
Balancing Procedures GSP9720JLR Wheel Balancer Operation Instructions
To Next Page
Loading...
