Once the upload is complete, restart the balancer turning it “off” and then back “on”
using power switch.
The updated specifications are now ready for use.
3.11 Motor Drive/Servo-Stop
The intelligent DC motor drive on the GSP9720JLR is able to position and hold the
tire assembly in position for weight application, apply different amounts of torque, and
control the speed and direction of the spindle.
If Servo-Stop is enabled, when the “Start” button is pushed with the hood in the
raised position, while weights are showing, the motor will automatically rotate the
wheel to the next weight plane and hold the assembly in position for weight or mark
application.
Servo-Stop can be enabled or disabled from the “Set Up” primary screen. Refer to
“Servo-Stop,” page 113.
3.12 Spindle-Lok® Feature
Depressing the foot pedal will lock the spindle. Locking the spindle will stabilize the
wheel for attaching weights at precise locations if automatic weight positioning is
disabled, and will allow for tightening and loosening of the wing nut. Do not use the
Spindle-Lok® as a brake to stop a spinning wheel.
NOTE: Depressing the foot pedal will cancel Servo-Stop.
CAUTION: Using the Spindle-Lok® to stop a spinning wheel may result
in personal injury or damage to the balancer.
3.13 Balance Primary Screen
The “Balance” primary screen has a choice of two related views:
Set Dimensions
Apply Weights
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
43
To Next Page
Loading...
