Real-Time Predictions with RimScan and SmartWeight
®
Once dimensions are measured, the balance screen will display the corrective weight
required and the SmartWeight
®
static and couple forces, along with the RimScan
™
display identifying the weight location. If a single corrective weight is required
RimScan™ and SmartWeight
®
work together to further reduce the amount of weight
used.
Select “Set Dimensions” to illustrate RimScan™ profile. If the weight location cannot
be achieved or is undesirable, turn the control knob to change the weight position. As
the position changes, the SmartWeight
®
force graphs will display a prediction of the
force results corresponding to the weight.
3.22 BDC Laser Adhesive Weight Locator
Servo-Activated Laser automatically locates BDC to aid in fast adhesive weight
positioning.
During the mixed weights and adhesive weights balancing procedures, the BDC laser
locator automatically displays a vivid line at bottom dead center after a wheel has
been spun. The laser turns off when the wheel is spun again.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
75
To Next Page
Loading...
