Cone/Flange Plate Mounting
Wheels may be centered using the lugholes and center bore with a flange plate and
centering cone. It is important that a back mounted cone be used to support and
center the wheel when using flange plates.
The correct flange adaptor setup is determined by:
Measure and set the bolt circle diameter and number of studs to use
against the lug holes.
Set the number of lugholes as follows:
A three-lug wheel uses three studs.
A four-lug wheel uses four studs.
A five-lug wheel uses five studs.
A six-lug wheel uses three studs.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
33
To Next Page
Loading...
