Using Control Knob
The control knob is located to the right of the softkeys. The control knob accesses the
on-screen switches and manually inputs data. The available on-screen switches are
dependent upon the setup configuration of the balancer.
Pushing in on the control knob cycles through the available on-screen switches on the
current primary screen. Rotating the control knob clockwise or counter-clockwise
changes the setting for the selected on-screen switch.
For example, in the “Balance” primary screen, pushing in on the control knob will cycle
through the grams to ounces, the static and dynamic, and the SmartWeight/Standard
balance screen switches. After selecting an on-screen switch, the setting may be
selected by rotating the control knob. The “selected” switch is the one showing the
hand.
GSP9720JLR Wheel Balancer Operation Instructions Getting Started
11
To Next Page
Loading...
