When the file has been successfully saved to your storage device, you may log out
and proceed to upload the specifications to the balancer.
Upload Specifications to the Balancer
To upload a new spec file to the balancer, begin at the Logo Screen by pressing
"Update Specs" on row 3 of the softkeys.
The balancer should display the Balancer Spec Update screen.
Follow the on-screen instructions and insert the USB drive that contains the new
specification file. An external USB slot is located on the side of the balancer display.
Press “OK” after you have inserted the USB drive.
NOTE: If you wish to exit the uploading process at any time, a
“Cancel” key is available on the second row of softkeys.
Select the appropriate spec file (matching the name of the file you downloaded from
the Web) and press “OK”.
GSP9720JLR Wheel Balancer Operation Instructions Balancing Procedures
41
To Next Page
Loading...
