24 BALANCING PROCEDURES
To remove the Auto-Clamp™ assembly, slightly tap the
Spindle-Lok® foot pedal to release the pneumatically
powered spindle. Squeeze the levers on the Auto-
Clamp™ device to disconnect the Auto-Clamp™ locks
from the spindle, and slide the assembly off the spindle.
SQUEEZE
LEVERS
SQUEEZE
LEVERS
Figure 73.
Install the plastic clamping cup and Auto-Clamp™ device
by sliding onto the spindle shaft with the clamping cup
pressed against the wheel.
PLASTIC
CLAMPING
CUP
AUTO-CLAMP
DEVICE
Figure 70.
Rotate the Auto-Clamp™ device until it locks into place
on the spindle shaft.
ROTATE UNTIL LOCK
Figure 71.
Keep hands clear of clamping components
during Auto-Clamp™ operation.
Secure the wheel by tapping the Spindle-Lok® foot pedal
twice. The Auto-Clamp™ device will slide tightly against
the wheel.
TAP SPINDLE-LOK
FOOT PEDAL TWICE
Figure 72.
To Next Page
Loading...
