INSTALLATION
21
■
Remove slack from the cord by moving the
cord tensioner away from the end plate it is
looped around.
➤
If the tensioner must be moved more
than one-third of the headrail width
away from its end plate to remove
slack, re-tie the knot and trim the
excess cord.
➤
Do not put tension on the cord at this
time. Just remove the slack.
NOTE: Cord tensioner must be placed at
least 5" from the end plate on both sides.
■
Adjust the moving rail to vertical, if
necessary. Work from the front side of the
shade.
➤
Locate the Phillips screws on the
moving rail bracket.
➤
To adjust the bottom end of the moving
rail to the right, loosen the right screw
one-half turn, then tighten the left screw
one-half turn. Repeat until the rail is
properly aligned.
To Next Page
Loading...
