INSTALLATION
17
Headrail-Mounted Rechargeable Battery Wand
Insert the Rechargeable Battery Wand into the Battery Mount
NOTE: The rechargeable battery wand ships fully charged, so it is ready to install out of the
package.
■
Match the direction of the arrow on the underside of the battery wand with the arrow on
the battery mount.
■
Insert the nose of the battery wand into the cavity of the battery mount.
■
Push the battery wand flush into the mount until the battery snaps into place.
CAUTION: Failing to insert wand properly may cause it to fall out of the mount, posing
an injury risk and potentially damaging the wand. Additionally, when mounting on a door,
closing the door with excess force may cause battery wand to dislodge from the mount,
also posing an injury risk and possibly damaging the wand.
NOTE: When power is connected to the motor, a blue LED inside the control button
housing will flash to indicate the shading is ready for operation.
PowerView
®
Gen 3 Shading:
Proceed to “Operate the Shading” on page 21.
To Next Page
Loading...
