TROUBLESHOOTING
32
Problem
The shading raises or lowers unevenly, the fabric rubs against one end of
the headrail, or the bottom rail is uneven when fully raised. (continued)
Solution Apply Skew Adjustment Tape to the Rear Roller Shade
Using the tape strips and instruction guide in the Skew Adjustment Kit included
with your order, place the tape strips onto the window side of the rear roller
shade fabric. The number of tape strips and their placement depends on the type
and severity of the skew, as explained in the instruction guide.
Problem
The shading or shade is hard to raise or lower, or will not raise or lower.
Solution
Shadings cannot be forced into tight inside mount window openings. If an
inside mount, check that the headrail is installed correctly. Make sure there
is clearance between the ends of the shading or shade and the window
casement.
Check that the installation brackets are level and aligned. Adjust and/or shim
(not provided) to level, if necessary.
Problem
The vanes do not open when the shading is first operated.
Solution
Make sure the front shading is completely lowered and the rear shade is fully
raised.
Open and close the shading several times to help open the vanes. If necessary,
gently pull down on the bottom rail when the shading is fully lowered.
Tape
Strips
To Next Page
Loading...
