TROUBLESHOOTING
33
Problem
The vanes do not close fully when the shading stops in the lowest position.
Solution
A small distance between the front and back fabric facings in the fully closed
or open position is normal.
PowerView
®
Gen 3
only: If this distance is excessive or moves over time,
open the shading to its full “vane open” position and try again. If this does
not correct the problem, reset the bottom limit. See “Resetting the Shading (If
Necessary)” on page 26.
Problem
The shading raises from the sill when the vanes areclosed.
Solution
A small gap between the sill and the bottom of the shading is normal in the
fully lowered “vane closed” position. The gap is necessary to allow for the
unimpeded movement of the bottom rail.
PowerView
Gen 3
only: If this distance is excessive or moves over time,
open the shading to its full “vane open” position and try again. If this does
not correct the problem, reset the bottom limit. See “Resetting the Shading (If
Necessary)” on page 26.
Problem
PowerView only: Adjacent shadings do not roll up evenly.
Solution
It is considered normal if the roll-up on adjacent shadings is within
5
⁄
16
" of
each other. If one shading rolls up tighter than another, lower and raise both
shadings several times.
Reset the shading. See “Resetting the Shading (If Necessary)” on page 26.
Check that the shading fabric is not catching on any brackets or components.
Check that the fabric winds evenly and does not rub against the headrail.
If uneven, see“Adjusting the Bottom Rail Weight” on page 31.
Problem
The front sheer fabric of the front shading clings to the rear sheer fabric.
Solution
Lightly apply a static spray for home furnishings. Follow the manufacturer’s
directions. Allow the shading to dry in the fully lowered position. If necessary,
reapply the static spray each time the shading is professionally cleaned.
To Next Page
Loading...
