Huvitz Excelon XD - Processing Speed and Clamp Pressure

Excelon XD/XQ Operator’s Manual 99
6.3.7 Clamp Pressure
Setup default clamping pressure for each lens material.
6.3.8 Processing Speed
• Rotation Limit
Set amount of lens rotation for each edging step.
• Rotation Speed
Set lens rotation speed for each edging step and each material.
• Roughing Y Speed
Set the fall speed of the lens when roughing edging started.
• These values are closely related to the quality of the edged lens so keep the
factory default values.
• Too high “Rotation Speed” values cause axis distortion during edging.
!
CAUTION
After adding(+) in SFB Front side