Huvitz Excelon XD - Edging Default

86 Excelon XD/XQ Operator’s Manual
Select R/L Sync Mode
• Safety Check
Setup parameters for safety check function.
Safety Check Margin – Margin value for lens adaptor
Frame Change Margin – Margin value for frame change lens
Use Small Lens Adaptor – Show warning message when small lens adaptor
needed
6.1.3 Edging Default
• Use edging side warning message
If the start edging side is different with “Default Edging Side”, warning
message displayed on the screen.
• Lens Material
Select default lens material (Plastic, Polycarbonate, HI-Index, Glass,
Trivex® )
• Use Fragile Mode
Select default safety mode (Fragile mode, Normal mode)
• Default Edging Type
Select default edging type
• Beveling Default Option
Set default options for bevel edging
• Flat/Grooving Default Option
Set default options for rimless edging
• Safety Beveling Option
Set amount of the safety beveling (front/rear small/rear large)