• Polish Wheel Size
Enter compensation value for polishing wheel size.
• Max Rimless Thickness
Set maximum lens thickness for rimless edging. (This value should match
the width of the wheel)
• Wheel for HI
Select the roughing edging wheel for HI-Index lens.
• Feeling Outside of Bevel
Enable or disable feeling outside of bevel.
• Bevel Height
Set bevel height value for “Feeling Outside of Bevel” function.
• PC, TRI Edging Order
Change the edging order of PC/TRI lens.
• Swap Pump 1,2
OFF – Used as it is
ON – Swap the function of Pump 1 and Pump 2.
(Swap pump could be used when Pump 1 is out of order, Temporarily, Pump
2 can be used instead of Pump 1)
• Switch GL Roughing Rotation
Change roughing rotation direction of Glass lens (a round)
To Next Page
Loading...
