• X Pos Reference/ Y Pos Reference
Select default hole position coordinates reference
X (Horizontal) – frame center / temporal box / nasal box
Y (Vertical) – frame center / Top box / Bottom Box
• Tilting Angle Mode
Set default titling mode (auto, manual)
• Tilting Ref Surface
Select default tilting reference surface (front, back)
• Default Value (Depth, Diameter, tilting angle)
Set default values
• Confirm Hole Delete
Show confirm dialog box when the hole delete button pressed.
• Hole Data Loading Type
Select hole data loading method
• Use Hole Data Preset
Show hole data preset buttons in the hole editor screen
• Confirm preset load
Show confirm dialog box when the hole preset button pressed.
• Use Demo Lens Curve (Automatic correction of hole position)
Apply demo lens curve value for drilling
• Default Demo Lens Curve
Set default demo lens curve value
• Drill Bit Warning Message
Show warning message when the diameter of the hole is smaller than the
drill bit.
• Digital Ptn : Coordinates Compensation
Select compensation method of the Digital Patterned hole data.
• Enable Hole Retouch Mode
Enable Drilling Retouch.
To Next Page
Loading...
