Excelon XD/XQ Operator’s Manual 13
damage to a cable connector(s) or receptacle(s), let the damage(s) be repaired
by an authorized service technician.
(12) Please do not pull on any cable. Always hold on to the plug when disconnecting
cables.
(13) Before every operation, visually check the equipment for exterior mechanical
damage(s) and for proper function.
(14) Do not cover any ventilation grids or slits. Immediately turn off and unplug any
equipment that gives off smoke, sparks, strange noises, or odors.
(15) Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to the instructions.
(16) Edger produces a noise. To prevention of the noise damage, You use the
earplug.
(17) When you carry this product, please use a hand cart. At least three persons are
necessary to lift the equipment.
(18) To avoid the risk of electronic shock, this equipment must only be connected to
a supply mains with protective earth.
(19) Do not position the equipment so that it is difficult to operate the disconnecting
device. (disconnecting device : power cord)
(20) This machine might be impaired if used in a manner not specified by
manufacturer and this manual.
(21) When you carry this product, please use both handles on left and right side of the
product. If you want the product to be installed on another place, please call A/S
center.
To Next Page
Loading...
