• Be sure to carry out the Edging Process in Safety Mode ( ) in case the lens
may be broken or the axis may be tilted during the edging process.
• Select “Safety Mode” or adjust clamp pressure in case the lens may be broken.
• Grooving and Polishing is not available for the Glass Lens. Be sure the material
of lens is matched with the job options selected in the display before starting the
Edging Mode.
• Moisture on the surface of the lens may cause axis problems, always use a new
LEAP-III™ tape.
• The safety beveling for glass lenses should be performed both front and rear
side. Otherwise, it will cause the damage to the human skin.
• To prevent the distortion of axis, you should put stickers for blocking of
hydrophobic lenses. Stickers are provided by lens manufacturers. Otherwise,
we do not guarantee the quality of the stickers.
To Next Page
Loading...
