1.1
SECTION 1 - INSTALLATION
Upon delivery of your new H10A saw, it is imperative that a thorough inspection be undertaken to check for any damage
that could have been sustained during shipping. Special attention should be paid to the electrical and hydraulic systems
to check for damaged cords and hoses, or for uid leaks. In the event of damage caused during shipping, contact your
carrier to le for a damage claim.
LIFTING MACHINE
This machine is to be lifted in one, fully assembled piece. In order to lift the machine it needs to be in the following
condition:
• Saw head in the down position
• Shuttle vise fully forward
• Coolant tank emptied
The H10A may be lifted from the FRONT with a forklift, which has a minimum capacity of 4500 lbs (2040 kg) and a fork
length of 72” (1830mm).
The machine is shipped on sections of 4 x 4 tubing. The tubing blocks should be removed prior to locating the machine
onto the shop oor.
To Next Page
Loading...
