Hydrafeed MSV 65 - Mechanism Diagrams; Assembly and Part Identification

174
10. Parameter List
10.1 User parameter list
5
Bar rack angle
degree
Function ON [ ] OFF [ ]
Position setting mm
6
. Back stop
Timer sec
7 Chucking mode Function ON [ ] OFF [ ]
8 Center line correction mm
9 setting record
Eject remnant by
pushrod
[ ]
2. Eject remnant
Eject remnant by new
bar
[ ]
Shaft load Function ON [ ] OFF [ ]
Function ON [ ] OFF [ ]
Setting value Pcs
3 Part counter
Stop at bar change ON [ ] OFF [ ]
4.Bar length(MAX setting) mm
5 Hexagonal bar time
setting
sec
6. 1st feed error
correction
mm
10
Other
Chuck close bar check
torque value setting
Servo torque value