Hydrafeed MSV 65 - 3 User Setup; User Setup Introduction

21
3. User Setup
3. User Setup
3.1 User Setup Introduction
`
1.Bar type / Diameter
3.position setup
4. Feeding type
1. Sub spindle pull
2. Barfeeding with / without turret
3. Multi
p
le fed com
p
onents
4. Feeding against moving turret
1. End of bar position
2. Loading selection
3. Pushrod retract position
4. Material selection
5. Push torque adjustment
1. Bar type
2. Bar diameter
3. The number of times for trying
push new profile bar pass
through the chuck
2.Component length
5. Bar rack angle
6. Back stop
7. Chucking mode