Hydrafeed MSV 65 - System Setup Introduction

79
4. System Setup
4.1 System Setup Introduction
System Setup
1. Interface signals
selection
1. Barfeeder to CNC
signals selection
2. CNC to Barfeeder
signals selection
3. Interface signal
optional function
Changing CNC AUTO
to MANUAL mode
while bar feeder in
auto c
y
cle
3. Loading position setup
2. Carriage position setup
4. Lathe selection
5. Chuck open/close bar check function setup
6. Time delay for chuck close then pushrod retract setup
7. Bar end then turret comes to part off position function setup
8. Cover operation function setup
9. Servo motor speed value setting
10. DEMO function
11. Sensor position setting
13. Language selection
15. Maintenance
12. Chuck type selection
14. Shaft loading space setting
16. Pulse output selection
18. Thickness of shaft load plate
17. Flag adjustment
19. Eject remnant by new bar option