176
10. Parameter List
10.2 System Parameter List
Single spindle lathe [ ]
4 Lathe selection
Double spindle lathe [ ]
Chuck open bar check [ ]
5
Chuck open/close bar check
function setup
Chuck close bar check [ ]
6
Time delay for chuck close then
pushrod retract setup
sec
By time [ ]
7
Bar end then turret comes to
part off position function setup
By M code finish signal [ ]
8 Cover operation function setup Cover Lock override [ ]
9 Servo motor speed value setting
10 DEMO function Bar feeder demo function [ ]
11
Bar length measuring sensor
position
mm
Normal chuck [ ]
12 Chuck type selection
Revese chuck [ ]
13 Language selection
14
shaft loading
space setting
E mm
15 Maintenance Cycle : times
CH0 : Y0 , Y1 [ ]
16 Pulse output selection
CH1 : Y2 , Y3 [ ]
17 Thickness of shaft load plate mm
BY CNC chuck signal [ ]
18 Back stop option
BY Barfeeder foot switch with timer [ ]
Load new bar and wait [ ]
19 Eject remnant by new bar option
Load new bar to material sensor
and wait
[ ]
To Next Page
Loading...
