84
4. System Setup
If select “ Bar feeder stop completely”
Changing CNC auto to manual mode while bar feeder is in auto cycle ,bar feeder will stop
completely ,
“
NC was in auto mode but not now, Now bar feeder stop completely!!
“
If select “ Bar feeder waiting CNC auto mode to continue” :
Changing CNC auto to manual mode while bar feeder is in auto cycle ,
(1) bar feeder will waiting CNC auto mode ,to continue Alarm symbol “21A CNC was in auto
mode but not now, Now bar feeder waiting CNC auto mode to continue!! “ .
(2) During bar feeder in operation ,changing CNC auto to manual mode ,bar feeder will stop
completely Alarm symbol “21 CNC was in auto mode but not now, Now bar feeder stop
completely!! “ appear.
To Next Page
Loading...
