Hypertherm HySpeed HT2000 - POST-INSTALLATION; Introduction; System Checkout; Set Switches and Check Torch

HySpeed HT2000 Instruction Manual 5-1
19
Section 5
POST-INSTALLATION
In this section:
Introduction ...............................................................................................................................................................5-2
System Checkout......................................................................................................................................................5-3
Set Switches and Check Torch ........................................................................................................................5-3
Turn Gases On.................................................................................................................................................5-3
Turn Power Supply On and Adjust Voltage/Current .........................................................................................5-3
Adjust Preflow Gases.......................................................................................................................................5-5
Adjust Cut Flow Gases and Check Initial Height Sensing (IHS) ......................................................................5-5
Final Torch Adjustment.....................................................................................................................................5-6
Check Torch Height Control (THC) and V/C Module........................................................................................5-6