Hypertherm HySpeed HT2000 - OPERATION; Front Panel Controls and Indicators; Power Supply; STATUS Indicators Before Startup

HySpeed HT2000 Instruction Manual 6-1
22
Section 6
OPERATION
In this section:
Front Panel Controls and Indicators .........................................................................................................................6-2
Power Supply ...................................................................................................................................................6-2
STATUS Indicators Before Startup ..................................................................................................................6-3
Gas Console ....................................................................................................................................................6-4
Digital Remote (DR) V/C Module .....................................................................................................................6-6
Programmable Remote (PR) V/C Module........................................................................................................6-7
Timer / Counter ................................................................................................................................................6-7
Noise Levels (Decibels) ............................................................................................................................................6-8
Daily Start-Up ...........................................................................................................................................................6-9
Check Torch.....................................................................................................................................................6-9
Turn Gases On.................................................................................................................................................6-9
Turn Power Supply On and Adjust Voltage/Current.......................................................................................6-10
Adjust Preflow Gases.....................................................................................................................................6-10
Adjust Cut Flow Gases and Prepare for Cutting ............................................................................................6-11
Common Cutting Faults ..........................................................................................................................................6-11
Technical Questions ...............................................................................................................................................6-12
Cut Charts...............................................................................................................................................................6-12
Conversions............................................................................................................................................................6-12
Cut Charts and Consumable Parts Index ...............................................................................................................6-13
Changing Consumable Parts..................................................................................................................................6-36
Removal and Inspection.................................................................................................................................6-37
Replacement ..................................................................................................................................................6-38
Changing the Water Tube ..............................................................................................................................6-39
How to Optimize Cut Quality...................................................................................................................................6-40
Tips for Table and Torch ................................................................................................................................6-40
Plasma Set-up Tips........................................................................................................................................6-40
Maximize the Life of Consumable Parts.........................................................................................................6-40
Additional Factors of Cut Quality....................................................................................................................6-41
Additional Improvements................................................................................................................................6-42