Hypertherm Powermax 85 Operator's Manual

powermax 65/85 Operator Manual 5-1
Section 5
MAINTENANCE AND REPAIR
In this section:
Perform routine maintenance .......................................................................................................................... 5-2
Inspect the consumables ................................................................................................................................. 5-3
Basic troubleshooting ....................................................................................................................................... 5-4
Fault codes and solutions ................................................................................................................................ 5-6
Replace the gas filter element ......................................................................................................................5-10

Hypertherm Powermax 85 Specifications

General

Gas Supply	Clean, dry, oil-free air or nitrogen
Cooling Method	Fan-cooled
Input Voltage	200-600V, 3-phase
Current Output	25-85 A
Duty Cycle	60% @ 85 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Cutting Capacity (Recommended)	1" (25 mm)
Gas Type	Air/Nitrogen