Hypertherm Powermax 85 Operator's Manual

TORCH SETUP
3-18 powermax 65/85 Operator Manual
Connecting an optional remote-start pendant
Powermax65 and Powermax85 configurations with a Duramax machine torch can include an
optional 25-foot (7.6 m), 50-foot (15 m), or 75-foot (23 m) remote-start pendant. Remove the
receptacle cover and plug the Hypertherm remote-start pendant into the receptacle on the rear of
the power supply.
ote:N The remote-start pendant is for use only with a machine torch. It will not operate if a
handheld torch is installed.
Receptacle for the
remote-start pendant or a
machine interface cable.

Hypertherm Powermax 85 Specifications

General

Gas Supply	Clean, dry, oil-free air or nitrogen
Cooling Method	Fan-cooled
Input Voltage	200-600V, 3-phase
Current Output	25-85 A
Duty Cycle	60% @ 85 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Cutting Capacity (Recommended)	1" (25 mm)
Gas Type	Air/Nitrogen