Hypertherm Powermax 85 Operator's Manual

TABLE OF CONTENTS
x powermax 65/85 Operator Manual
Using the machine torch ................................................................................................................................4-24
Ensure the torch and table are set up correctly .............................................................................4-24
Understand and optimize cut quality .................................................................................................4-24
To pierce a workpiece using the machine torch ............................................................................4-27
Common machine-cutting faults ........................................................................................................4-27
Section 5
Maintenance and Repair
Perform routine maintenance .......................................................................................................................... 5-2
Inspect the consumables ................................................................................................................................. 5-3
Basic troubleshooting ....................................................................................................................................... 5-4
Fault codes and solutions ................................................................................................................................ 5-6
Replace the gas filter element ......................................................................................................................5-10
Section 6
Parts
Power supply parts ............................................................................................................................................ 6-2
Hand torch replacement parts ........................................................................................................................ 6-5
H65/H85 ................................................................................................................................................... 6-5
H65s/H85s ............................................................................................................................................... 6-5
Hand torch consumables ...................................................................................................................... 6-8
Machine torch replacement parts .................................................................................................................. 6-9
M65/M85/M65m/M85m ....................................................................................................................... 6-9
Machine torch consumables ...............................................................................................................6-12
Accessory parts................................................................................................................................................6-14
Powermax65/85 labels ...................................................................................................................................6-15

Hypertherm Powermax 85 Specifications

General

Gas Supply	Clean, dry, oil-free air or nitrogen
Cooling Method	Fan-cooled
Input Voltage	200-600V, 3-phase
Current Output	25-85 A
Duty Cycle	60% @ 85 A
Recommended Gas Inlet Flow Rate/Pressure	6.7 scfm @ 85 psi
Cutting Capacity (Recommended)	1" (25 mm)
Gas Type	Air/Nitrogen