Hypertherm Powermax 85 Operator's Manual

TORCH SETUP
3-20 powermax 65/85 Operator Manual
ote:N The cover on the machine interface receptacle prevents dust and moisture from
damaging the receptacle when not in use. This cover should be replaced if damaged or
lost (part number 127204).
See Section 6, Parts for more information.
Installation of the machine interface cable must be performed by a qualified service technician. To
install a machine interface cable:
1. Turn OFF the power and disconnect the power cord.
2. Remove the machine interface receptacle’s cover from the rear of the power supply.
3. Connect the Hypertherm machine interface cable to the power supply.
4. If you are using a cable with a D-sub connector on the other end, plug it into the appropriate
pin connector on the torch height controller or CNC. Secure it with the screws on the D-sub
connector.
If you are using a cable with wires and spade connectors on the other end, terminate the
machine interface cable inside the electrical enclosure of listed and certified torch height
controllers or CNC controllers to prevent unauthorized access to the connections after
installation. Verify that the connections are correct and that all live parts are enclosed and
protected before operating the equipment.
ote:N The integration of Hypertherm equipment and customer-supplied equipment including
interconnecting cords and cables, if not listed and certified as a system, is subject to
inspection by local authorities at the final installation site.
The connector sockets for each type of signal available through the machine interface cable are
shown in the figure below. The table provides details about each signal type.

Hypertherm Powermax 85 Specifications

General

Brand	Hypertherm
Model	Powermax 85
Category	Welding System
Language	English