Procedure
1. Push and hold the safety lever.
2. Pull the trigger switch.
3.5.2 Low-noise muffler
The low-noise muffler decreases the sound emission of the tool to 80 dB.
Caution:
• HYTORC recommends to calibrate the tool after:
• the modification of the tool.
• the replacement of the low-noise muffler.
The low-noise muffler has an effect on the torque output.
• Replace the low-noise muffler when it is discolored, clogged or after every
five hours of operation.
Procedure
1. Remove the low-noise muffler (A)
from the bottom plate (B).
2. Install the new low-noise muffler
(A).
When you must replace the low-noise muffler, refer to the table below to select and order the cor-
rect part number.
Description
47 - 001 - 15
To Next Page
Loading...
