• Do not use FRLs, pneumatic hoses, hose connections with hose couplings, power
cables or remote control cables to carry or move the equipment. Always hold the FRL
or the tool to carry or move the equipment.
• Store tools and accessories which are not in use properly.
2.2 Additional safety instructions
2.2.1 FRL
• Only use HYTORC FRLs.
• Do not modify the FRL in any way.
• Metal-to-metal contact can cause sparks. Take appropriate additional measures.
• Make sure that the air supply pressure is between 6.2 bar (90 psi) and 10 bar (145
psi).
• Make sure that the maximum outgoing operating pressure of the FRL is not higher
than the maximum permitted pressure of 6.2 bar (90 psi).
• Make sure that the FRL is filled with the (supplied) lubricating oil (Shell Tellus S2 VX
32).
• Make sure that the oil level in the oil filter reservoir is beween the minimum mark and
the maximum mark. Use the oil level sight glasses to check the oil level.
• Do not mix different grades of lubrication oil.
• Make sure that the oil filler cap is placed on the oil filling point.
2.2.2 Pneumatic hoses
• Only use HYTORC pneumatic hoses.
• Do not modify the pneumatic hoses in any way.
• Make sure that the pneumatic hoses are securely connected.
• Make sure that the pneumatic hoses are not kinked or twisted.
• Keep the pneumatic hoses away from the reaction point.
• Replace damaged pneumatic hoses immediately. Replace the pneumatic hoses at
least every three years.
2.2.3 Reaction arms
• Only use HYTORC reaction arms.
• Do not modify the reaction arms in any way.
• Place the reaction arm against a solid reaction point that can handle the load.
• Only place the reaction area against the reaction point.
Safety
47 - 001 - 9
To Next Page
Loading...
Need help?
General
