78
9. Maintenance and Inspection
SA7C
[Items Required for Replacement]
• Replacement motor M-P2SA7C-IAP56N-MB-CO
(with a coupling on the motor shaft; see the photograph right.)
• Allen wrench set • Phillips screwdriver
• Grease (Kyodo Yushi’s Multemp LRL3 or equivalent)
[Procedure]
1) After removing the flat countersunk-head screws (M3 × 8, 2 pcs.) affixing the cable ends on the motor end cap,
remove the pan-head screws (M3 × 105, 4 pcs.) affixing the motor end cap.
• Pan-head screws (M3 × 105, 4 pcs.)
• Flat countersunk-head screws (M3 × 8, 2 pcs.)
Coupling
To Next Page
Loading...
Need help?
General
