IBM 106

24. Unpacking the Model 106 using lift handles............................................................................................31
25. Middle slide – fully extended (Slide release latch identied above).......................................................33
26. Middle slide release detail........................................................................................................................33
27. CMA attachment........................................................................................................................................34
28. CMA attachment aligned with outer slide................................................................................................ 35
29. Panhead screws ....................................................................................................................................... 35
30. CMA attachment installed on outer slide................................................................................................. 36
31. Location detail...........................................................................................................................................36
32. Fastener detail.......................................................................................................................................... 37
33. Attachment spring detail.......................................................................................................................... 37
34. Front rack post attachment details.......................................................................................................... 38
35. Attachment spring.....................................................................................................................................38
36. Rack post square hole location detail...................................................................................................... 39
37. Not good - example...................................................................................................................................40
38. Good - example.........................................................................................................................................40
39. Safe−handling thumbnails: inserting the chassis with rails into the rack...............................................41
40. Rail slide alignment detail.........................................................................................................................41
41. Inner view - example................................................................................................................................ 42
42. Outer view - example................................................................................................................................42
43. CMA attachment bracket.......................................................................................................................... 42
44. Panhead screws........................................................................................................................................ 43
45. Installed on 4U chassis.............................................................................................................................43
46. CMA “B” bracket ...................................................................................................................................... 43
47. CMA ramp "lip"..........................................................................................................................................44
48. CMA “A” bracket ...................................................................................................................................... 44
viii