c) Fix the rail with 1x M4 screw. One screw is required per inner bracket. See c in the following gure.
Figure 24. Installing the sliding rails
3. Mount the rails to the rack posts. For reference about the pins location in the front and the rear rack
posts, see the following gure.
Figure 25. Rear and front rack posts
a) Retract and hold the front retention bracket. See a in the following gure.
b) Insert the pegs on the mounting flange into the rack holes. See b in the following gure.
44
IBM Storage Scale System 6000: Hardware Planning and Installation Guide
To Next Page
Loading...
