IBM AS/400 9401 P03 - Twinaxial Nonprogrammable Workstation as the System Console

• Programmable Workstation Local Attachment for Macintosh**
The console is the following:
- Macintosh computer running the SNA•ps** 5250 Version 1.2 application that uses the LocalTalk**
protocol
Go to "Macintosh Workstation as the System Console" on page 3-4.
Twinaxial Nonprogrammable Workstation as the System Console
If you have a twinaxial workstation as the system console, perform the following steps:
1 Prepare the twinaxial workstation using the device information.
Notes:
a. Be sure the workstation address is set to zero (0).
b. Verify that the cable is labeled at both ends.
2 Ensure that the workstation power cord is not plugged in the ac outlet.
3 Ensure that the twinaxial workstation cable is connected at the workstation.
4 Install the system-unit end of the twinaxial attachment cable to the twinaxial workstation connector
on the back of the 9401 System Unit.
RV3D266 ·1
5 Connect the twinaxial attachment cable to the twinaxial cable that is connected to the workstation.
Note: If the twinaxial attachment cable has two ports available, connect the twinaxial workstation
cable to port 0.
3-2 AS /4 00 9401 In stallation • Models P03 and 1 OS V3R1