Chapter
8.
Set the System Values
This chapter provides instructions for setting the system time and date, installing applications, and printing
the system configuration list.
Set the System Date and Time
1 Set the system date. The default value for the system date
is
mmddyy.
mm=
month
dd
=day
yy
=year
Where mmddyy appears
in
this procedure, type the current date. For example, the date for Feb-
ruary
7,
1995 would
be
entered
as
020795. The system date format can also
be
yymmdd or
ddmmyy.
On
the command line
of
the AS/400 Main Menu, type the following and press the Enter key:
chgsysval sysval (qdate) value('mmddyy')
2 Set the system time.
The default value for the system time
is
hhmmss.
hh
= hour
(1
through
24)
mm=
minutes
ss
=seconds
Where hhmmss appears
in
this procedure, type the current time. For example, the time 4:30 p.m.
(12-hour clock) would
be
entered as 163000.
On
the command line of the AS/400 Main Menu, type the following and press the Enter key:
chgsysval sysval (qtime) value('hhmmss')
3 Change the message queue
to
Break mode.
On
the command line of the AS/400 Main Menu, type the following and press the Enter key:
chgmsgq
qsysopr *break sev(65)
4 Press
F3
(Exit) until you reach the AS/400 Main Menu.
5
Do
you need
to
install licensed programs?
No
Yes
Go
to
the Software Installation book
to
install the licensed programs. Return here and
continue with the next step
in
this procedure.
© Copyright IBM Corp. 1995
8-1
To Next Page
Loading...
