Appendix
B.
Select I
PL
Type and Mode
Use
the
information
in
this chapter
to
select and verify the IPL type and mode. Function
02
allows
you
to
select IPL type and mode. Function
01
allows
you
to
display the last IPL type and mode that was
selected. See Figure 2-2
on
page 2-4 for control panel locations.
Function
01
- Display Selected IPL Type and Mode
To
display the last IPL type and mode that was selected, perform the following procedure:
1 Select function
01
by pressing the
Up
(
t)
or Down
O)
pushbutton until
01
is
shown
in
the
Function/Data display
on
the control panel.
2 Press Enter
on
the control panel.
3 The last IPL type and mode that was selected
is
shown
in
the Function/Data display.
This ends the procedure.
Function 02 - Select IPL Type and Mode
Function
02
allows you to select the IPL type
(A,
B,
C,
or
D)
and IPL mode (M or
N).
A
IPL
from disk
B
IPL
from disk
C Reserved
D
IPL
from tape
M Manual mode
N Normal mode
To
select the IPL type and mode, perform the following procedure:
Note: Function
02
has eight possible combinations of IPL and mode selections. There are four IPL
selections
in
Normal
(N)
mode and four IPL selections
in
Manual (M) mode. Ensure that
you
are
selecting the correct IPL type and mode.
1 Select function
02
by pressing the
Up
(
t)
or Down (
~)
pushbutton until
02
is
shown
in
the
Function/Data display
on
the control panel.
© Copyright
IBM
Corp. 1995
B-1
To Next Page
Loading...
