DANGER
An electrical outlet that
is
not correctly wired could place hazardous voltage on metal parts
of
the system
or
the products that attach to the system. It is the customer's responsibility
to ensure that the outlet
is
correctly wired and grounded to prevent an electrical shock.
(RSFTD201)
DANGER
To prevent a possible electrical shock when installing the system, ensure that the power
cords
for
all devices are unplugged before installing signal cables.
rRsFro2
021
DANGER
To prevent a possible electrical shock when adding
or
removing any devices
to
or
from the
system, ensure that the power cords
for
those devices are unplugged before the signal
cables are connected
or
disconnected. If possible, disconnect all power cords from the
existing system before you add
or
remove a device.
rRsFro
203J
Caution Notices
A caution notice calls attention to a situation that
is
potentially hazardous to people because of some
existing condition.
CAUTION:
Do
not plug the power cable into the power outlet at this time. rR
sFrco15
J
CAUTION:
Telecommunications Statement: This unit contains over-voltage circuits between the ac power
outlet and the unit. These circuits meet the standard limits described in International Electrical
Commission
(IEC)
664,
installation category
II.
It is the customer's responsibility
to
ensure that the
power outlet meets the standards of
IEC
664,
installation category
II.
(RsFTc
21
4J
Warning Notices
A warning notice indicates the possibility of damage to a program, device, system, or data.
Product Recycling
This unit contains recyclable materials. The unit should be recycled where facilities are available and
according to local regulations.
In
some areas IBM will provide a product take-back program that ensures
proper handling of the product. Contact your IBM representative for more information.
Product Disposal
T
hi
s unit may conta
in
batteries that a
re
accessible to certified service personnel only. Before disposi
ng
the unit, these batteries must be removed and discarded or recycled accordi
ng
to local regulations.
Contact your IBM representative to remove these batteries.
Vi
AS/4
00
94
01 Installation - Models P03 and 10S V
3R
1
.J
J
To Next Page
Loading...
