6 The Verify Contact Information display appears.
To perform the Licensed Internal Code Preventive Service Planning (PSP) test, press the Enter key.
7 The Select Reporting Option display appears.
Select the Send service request
now
option and press the Enter key.
Messages showing the status of the request are shown at the bottom of the display.
8 The IBM Welcome Packet display appears.
IBM
We
l cooe
Pa
ck
et
Systet1:
X.GX.
Type
choice, press Enter.
Welcome
Packet avai1able • , .
FJ
"'
[xit
F1
2=Canc
el
9
Do
you have an AS/400 Welcome Packet?
No Yes
See the AS/400 Guide
to
Remote Marketing Support
and
IBMLink information in the
AS/400 welcome packet for instructions
on
how to enter the information and test the
IBMLink, then return here.
Go to Chapter 8, "Set the System Values"
on
page 8-1.
This
ends
the procedure.
10
In
the Welcome Packet available field, type n and press the Enter key.
11
Note: To register for IBM remote marketing services, contact your marketing representative.
You have completed the test of the electronic customer support remote services.
Press the Enter key.
12 The AS/400 Main Menu appears.
13 Go to Chapter 8, "Set the System Values"
on
page 8-1.
This
ends
the
procedure.
7-6 AS/400
9401
In
stallation - Models
PD3
and
108
V3R1
To Next Page
Loading...
