4 Attach the cables:
Warning: Attaching the cable with the ThinkPad powered
on
may cause damage to the ThinkPad
or the PCMCIA adapter.
a.
Install the workstation end of the PCMCIA cable
rJ
to the PCMCIA adapter
in
the ThinkPad.
Note: Ensure that the cable notch is
in
the down position.
b.
Find the personal computer (PC) cable that was shipped with the
9401
System Unit.
Attach the system unit end of the
PC
cable
DI
to the workstation connector
on
the back
of
the
9401
System Unit.
RV3D
27
0-1
c.
Attach the workstation end of the
PC
cable to the PCMCIA cable pod
El
.
Verify that the cable is labeled at both ends.
5 Ensure that the Thinkpad
is
powered off.
6 Go to Chapter 4, "Connect the Cable and Modem for Electronic Customer Support"
on
page 4-1.
This ends the procedure.
3-8 AS/400 94
01
In
sta
ll
at
ion - Models P03 and 108 V3R1
To Next Page
Loading...
