L'
17 Perform the following:
• Set the A/S (asynchronous) switch
on
the front panel of the modem to the
In
position.
• Set the F/S switch
on
the front panel of the modem to the Out position for 2400 bps.
• Set all of the switches on the rear panel of the modem to the On (up) position (except for the
power switch).
18 Find the communications cable labeled
B.
Align the modem-unit end of the cable with the connector on the modem. Push the cable connector
in and tighten the thumbscrews.
19
Is
the telephone
or
telephone jack installed (for the electronic customer support modem)?
No
Yes
Perform the following:
• For the
IBM
5853 modem, connect the
Line
socket on the modem to the tele-
phone jack. You can optionally connect a telephone to this modem using the
Set
socket.
• For other modems, see the device (modem) information for instructions.
Continue with the next step of this procedure.
20 You have completed connecting the cable and modem for electronic customer support.
Go to Chapter
5,
"Install Additional Devices" on page 5-1.
This ends the procedure.
Chapter 4. Connect the Cable and Modem for Electronic Customer Suppo
rt
4-5
To Next Page
Loading...
